PEK-120 is the development module of full digital controlled Buck Converter, aiming at the training of circuit analysis, design, simulation and experiment for researchers to conduct problem-oriented learning. The quantitative design of power circuit and controller is based upon converter’s specifications. Users can further understand the related technology of Buck Converter through PSIM simulation verification and SimCoder programming processes.

The specifications of Buck Converter development module

Pulse Width Modulation Buck Converter

Experiment objective is to learn the principle of Pulse Width Modulation Buck Converter. Via PEK-120 module, students learn the voltage and current measurement method and the settings of TI F28335 DSP IC pin locations, PWM and A/D hardware as well as to understand how to conduct the control and measurement of DSP’s internal signal by RS-232.

Voltage Mode Control Buck Converter

Experiment objective is to learn the small signal model derivation of Buck Converter and the design of voltage and current loop controllers. After designing hardware SimCoder is utilized to conduct programming.

Average Current Mode Control Buck Converter

Experiment objective is to understand the method of Buck Converter’s Average Current Mode Control; small signal derivation of voltage and current loop, and the design of voltage and current loop controllers. After designing Buck Converter SimCoder is utilized to conduct programming.

MPPT Converter for PV System

Experiment objective is to understand PV module characteristics and various MPPT methods; and to learn SimCoder programming for perturb and observe method and incremental conductance method. PEK-120 is utilized to verify experiment results.

PV Battery Charger

Experiment objective is to learn PV battery charger’s control method for combining MPPT controller with battery’s three-stage controller. After designing PEK-120’s hardware SimCoder is utilized to conduct programming and to verify experiment results.