ISO-16750-2 Pretest with ASR-2000

Dear Madam/Sir,

The applications of electronic technology products are growing at a fast pace in our daily lives. Other than mobile phones, tablet computers or general consumer electronics, electronic technology products are also utilized in the automotive industry, including LED headlights / taillights, HUD (Head Up Display), adaptive front lighting, tire pressure monitoring system, ABS system, GPS, windshield wiper, AV system, etc. In order to ensure the safety of drivers and passengers as well as driving, vehicle manufacturers are required to have a higher product stability and stricter quality control standards for electronic devices installed in the automobile.

Vehicle driving process is an extremely harsh challenge for electronics manufacturers manufacturing automotive electronics. Rough-road driving, vibration from a piston-engine, electrical systems exposed to low or high temperatures, temporary exposure to unknown chemical mixtures, alternator overvoltage, and momentary drop in supply voltage all may cause the product to malfunction. Therefore, the environmental reliability requirements of automotive electronic products will be more rigorously regulated. At present, the ISO-16750 has been widely adopted and referenced by relevant automotive electronics manufacturers. ISO-16750 contains 5 parts. In addition to ISO-16750-1 General, the rest are ISO-16750-2 Electrical loads, ISO-16750-3 Mechanical loads, ISO-16750-4 Climate loads, and ISO-16750-5 Chemical loads. The sequence mode of ASR-2000 can arbitrarily edit the voltage test waveform, which is very suitable for generating the verification waveform of ISO-16750-2 Electrical loads.

ASR-2000 for the applications of ISO-16750-2 verification items are as follows:

※ Direct current supply voltage
ASR-2000 provides the maximum / minimum supply voltage to verify the DUT of a full
range of 12V power supply system and the 24V power supply system.

※ Overvoltage
ASR-2000 simulates the occurrence of overvoltage when the generator regulator fails.

※ Superimposed alternating voltage
The internal resistance parameter requirements of the power supply is not considered.
ASR-2000 collocating with a signal generator can simulate power output to have the frequency change from 1 to 999.9Hz.

※ Slow decrease and increase of supply voltage
ASR-2000 sequence mode can simulate the battery being gradually charged and discharged.

※ Momentary drop in supply voltage
Setting ASR-2000 power supply voltage to be interrupted instantaneously can simulate the effect caused by the melting of the conventional fuse component in another circuit. ASR-2000 can provide a minimum power interruption output of 100us.

※ Reset behaviour at voltage drop
ASR-2000 can flexibly set different voltage drop times to test the reset behaviour of the DUT.

※ Starting profile
The starting profile generated by ASR-2000 can verify the characteristics of the DUT during and after the car ignition.

※ Load dump
Load dump is generated when the battery powering the generator or inductive component is instantaneously disconnected. If the parameter requirements of the input impedance of the power supply are not considered, editing the ASR-2000's sequence mode can obtain the waveforms of ISO-16750 test A and test B.

※ Reversed voltage
ASR-2000 reversed output can meet the verification requirements of various automotive electronic products.

For more detailed application content, please contact GW Instek.
Sincerely yours,

Overseas Sales Department
Good Will Instrument Co., Ltd
No. 7-1, Jhongsing Road, Tucheng Dist.,
New Taipei City 23678, Taiwan R.O.C
Email: marketing@goodwill.com.tw

If you do not wish to receive our mails please write to marketing@goodwill.com.tw